BREEZEMAX EXTREME 5000 PDF
BreezeMAX Extreme is part of the carrier-class, field proven BreezeMAX product family and is the first wireless broadband solution to bring WiMAX 16e. BreezeMAX® Extreme WiMAX™ 16e pioneer for the license-exempt market WiMAX 16e for the License-exempt Market Main Features and Highlights. BreezeMAX Extreme is part of the carrier-class, field-proven BreezeMAX product family and brings WiMAX 16e technology to the 5 GHz license-exempt.
|Published (Last):||8 May 2011|
|PDF File Size:||1.68 Mb|
|ePub File Size:||20.66 Mb|
|Price:||Free* [*Free Regsitration Required]|
When using forwarding with option 82, if the Service Group gateway is a Cisco router the breezeemax configuration must be add on the Cisco to permit the DHCP packets to extremr The following is a general description: To refrain from unexpected network behavior it is recommended to set parameters to match the capabilities of the target downgrade version e. Recovery actions in case BTS was upgraded to 1.
Multi-host support behind a single CPE might not work.
Due to the requirements of FCC regulations, starting with release 1. After switching between Operation Modes e. When upgrading to release 1. Two extrwme flows which have the same priority are equalized by the CPE at packet rates and not bit rates the packet sizes are not taken into account. Ping messages of bytes transmitted over R1 to the host behind CPE are sometimes unanswered. One may need to implement timers or other logic scripts in the AAA to close these sessions.
When using Optimized Video service, it is recommended not to use DSCP values of 1, 8 and 9 for uplink data traffic other than video.
Upon successful completion the unit set automatically “run from shadow” and performs reset itself. For details on the required changes, please refer to the application note: The CPE will provision the services according to the order in which they are received until the breezemas is exceeded.
BreezeMAX Extreme | WiMAX technology 5 GHz license-exempt solution
Upgrade to Release 1. Although mentioned in recommendation 20, when operating in release 1. There is no issue observed with Ping messages of length up to 14K bytes. It corresponds to software versions: This is mainly since IP address The information is not submitted through the TR protocol.
CSassociate to it the forwarding rule you’ve created in step extrem. Update the Service Profile berezemax per your needs e. Under GPS chaining, when there is a faulty chaining cable, the radio units in the chain may not initiate transmission. The GPS synchronization may take up to 30min when installing the base station in a new location, installer may refer to the GPS Menus as detailed in the system manual 5.
Rocket M5 vs Alvarion BreezeMAX Extreme – Ubiquiti Networks Community
Cases in which the CPE is presented as linked, even though it is not. Known Issues and Limitations With Release 1. Alvarion reserves the right to alter the specifications in this publication without prior notice. NE failure when provisioning hreezemax capacity limit CPE model with services sum exceeding the capacity limit. The documentation includes the following: No disclosure thereof shall be made to third parties without the express written permission of Alvarion.
Please note that applying factory defaults will not change Country Code selection. Backhauling link must be under Eth. Such cases might occur when using limited license CPEs and the total number of services defined for such a CPE is above the licensed value.
BreezeMAX® Extreme 5000
When running Spectrum Analyzer while operating in dual sector mode, if system had developed misssynchronization because of GPS holdover, at the end of the scan process the system would reinitialize both channels. Aradial default installation of version 5. After link with BTS is established, the new version is Set breezemsx main automatically by the device In order to downgrade to release 1.
The material contained herein is proprietary, privileged, and confidential. If static routes are added to a device acting as DHCP client the routed classes will not perform traffic.
It is important to design carefully the frequency allocations and potential bands e. Cable to mains is NOT included and should be ordered separately. Radiator verified with version 4. Software is downloaded to the unit b.
Specifically when operating a dual-carrier BTS e. When deploying a multi sector site it is recommended using a single high profile GPS antenna kit along with GPS chaining cable CAT5e cable between the base-station on the same site. When operating with DHCP option 66 and 67, the CPE might not receive an IP if option 67 is not used only 66 or if the option 67 xml file is not at the specified location.
Note that these can be overcome with additional scripts and configuration of the default installed Radiator AAA: Update the desired Multiple Service Flows with the new service interface you have created. Please note, when downgrading from Release 1. Upgrade also the CPE to Release 1. When performing backhauling over Extreme CPE i.
De-register the MS to have the new setting in affect Network entry timeout prevent s full band scan in universal CC, thus workaround is needed to set only one BW to scan. Recommended workaround is to minimize GPS holdover events — improving antenna installation location insure clear skyexgreme high gain profile antenna In case of using country code with DFS: